Peugeot 308 Key Fob Replacement
Peugeot's 308 may be catching on a bit however it's still eye-catching. It's not the plushest car in its class and an Ford Focus or Volkswagen Golf will isolate you even better from imperfections on the road - but it's still a pleasant and pleasant driving experience.
We often receive requests from Coded Car Keys to replace peugeot key fobs. These tips can help whether the problem is persistent or intermittent.
Water Damage
If you accidentally drop your key fob in the puddle, or it gets wet while kayaking, canoeing, rafting or canyoning, the fob is likely to be damaged by water. The best way to avoid this from happening is to keep it in a dry bag when you're out in the open or engaging in activities in which the fob may be exposed to a lot of water.
It's also essential to make sure the fob has completely dried before you open it to use it again. If you detect any smells emanating from the fob like an industrial liquid smell or that of windshield washer fluid, it's another indication that it's submerged in water.
A wet circuit may cause the battery's charge to drain or even explode. If you can remove your keyfob 308 out of the water it is best to turn the button side up and shake as much water out as you can before opening the casing. Remove the battery, then wipe the circuit board clean with a cotton swab that is dipped in 90 percent alcohol.
Other causes why your Peugeot 308 remote entry keyless system might not work include a dead coin cell battery, receiver module problems signal interference, or a faulty chip. If none of these are the reason, you may try resetting the system by disconnecting the battery that is 12 volts for approximately 15 minutes.
Dead Coin Battery
Peugeot cars come with a remote-start feature that allows the driver to start the car from afar by warming up or cooling down the vehicle prior to getting in. This feature is extremely helpful, especially during cold winter months. But sometimes, the remote start system stops functioning due to a variety of reasons, like the battery of a coin that is dead.
The coin-shaped battery that is inside the key fob will last between two and four years based on how often it is utilized, the place it was purchased, and how it is used. The date for use-by is typically printed on the package or listed in the instruction manual.
If the key fob is not functioning after exposure to clean tap water and you want to remove the battery, then clean the electronic chip with a paper towel and isopropyl alcohol, then dry it completely before replacing it. If the key fob was exposed to soapy or salty water, it could have fried the chip. You'll need to replace it.
If you're not sure if the battery is defective You can test its voltage with a multimeter attached to both the terminals for plus and minus. peugeot replacement key fob should be between 12-13 volts but if it's lower, the battery should be replaced. You can also reset the computer in the onboard computer by disconnection and reconnecting the 12 volt batteries in reverse order. (positive cable first, then negative cable). The engine should start.
Faulty Receiver Module
If you aren't seeing the "Key Detected" message, it could mean the receiver module defective. It's the component that sends a signal to the car when your key fob is activated which also acts as an immobiliser and prevents it from starting until the key that you want to use is present.
This could be due to a variety of reasons, including water damage or simply getting old. If the electronic chip inside your Peugeot 308 keyfob has been damaged by dirty tap water it could be because the keyfob was exposed it. In this case, you'll need to take off the battery and clean it thoroughly with isopropyl alcohol, or electronic cleaner. Once the battery has dried you can try it again.
If the issue continues to persist, it is recommended to visit an area Peugeot expert or locksmith. They can use an instrument for diagnosing to identify the issue and fix it.
The loss of your Peugeot car keys could be an emotional experience. A reputable auto locksmith will be able to solve the problem within minutes. They can program your vehicle and cut a brand new, working key for you. Click here to find a local locksmith near you.
Faulty Electronic Chip
The electronic chip inside the Peugeot 308 key fob plays a vital role in the remote control system. If the chip is damaged, you could have problems starting your car or receive a message stating "anti-theft". If this occurs, the only option to fix the issue is to purchase a new key. Fortunately, auto locksmiths with experience are able to provide this service in the shortest time.
The chip inside your Peugeot 308's key fob could be damaged due to many reasons, including sweat, water damage, or dirt. If your Peugeot key fob has been exposed dirty or soapy water, it should be cleaned right away. You can clean the electronic component with the help of a towel that is soaked in isopropyl Alcohol. The battery should be allowed to dry completely.
Sometimes keys may cease to function due to radio interference. This can be caused by other devices that operate on the same frequency as your Peugeot key fob. It could also be caused by bad weather or objects in the vicinity of the vehicle. If you experience this problem it is advised to visit a Peugeot dealership.
The Peugeot 207/308 key fob is extremely delicate and requires extra attention. You should not drop it or throw it around. If you lose something, try to find it as quickly as you can. You can reset your on-board computer by disconnecting the battery for a couple of minutes. Be sure to disconnect the negative first, and then the positive.